t relevant parts of NQA-1 for guidance on implementation of this requirement. No corresponding requirement. Recommendations. GS-R-3 users should address this NQA-1 requirement. Consult relevant parts of NQA-1 for guidance on implementation of this requirement. No corresponding requirement. Recommendations. GS-R-3 users should address this NQA-1 requirement. Consult relevant parts of NQA-1 for guidance on implementation of this requirement. 10 Inspection 10-100 General 216.7 GS-R-3 Requirements 5.7 and 5.15 Recommendations.
GS-R-3 users should ensure that inspection for acceptance is performed by qualified persons other than those who per- formed or directly supervised the work. PART IV, SUBPART 4.7 Table I ASME NQA-1b-2011 The Extent to Which GS-R-3 Addresses NQA-1 Requirements (Cont'd) Requirement 10-200 Inspection Requirements 10-300 Inspection Hold Points 10-400 Inspection Planning 401 Planning NQA-1 GS-R-3 and Recommendations GS-R-3 Requirement 5.7 Recommendations. When specifying inspection requirements and acceptance criteria, GS-R-3 users should include specified requirements con- tained in the applicable design documents or other pertinent technical documents approved by the responsible design organization. No corresponding requirements. Recommendations. GS-R-3 users should address this NQA-1 requirement. Specified hold points should be indicated in asme pdf appropriate documents. Consult relevant parts of NQA-1 for guidance on implementation of this requirement. No corresponding requirements. 402 Sampling Recommendations. GS-R-3 UL Standard users should address these NQA-1 requirements. Consult relevant parts of NQA-1 for guidance on implementation of this requirement. 10-500 In-Process Inspection No corresponding requirements. Recommendations. GS-R-3 users should address this NQA-1 requirement. Consult relevant parts of NQA-1 for guidance on implementation of this requirement. 10-600 Final Inspections 601 602 603 604 Resolution of Nonconformances Inspection R