Over 16,526,050 people are on fubar.
What are you waiting for?
expanded metal; any openings shall conform to ISO 14120, EN 953 or ANSI/AMT B15.1, but api download in no case shall exceed 10 mm (0,375 in); guards of woven wire shall not be used; be constructed of steel, brass, aluminium or non-metallic (polymer) materials, as suitable; 7.2.14 If specified, coupling guards shall be constructed of an agreed spark-resistant material (see 6.10.2.6, note). 7.2.15 If specified for coupling guards with potentially explosive atmospheres, an Dignition hazard assessment (risk analysis) in accordance with EN 13463-1 shall be conducted and a suitable report provided. Single-piece drain-rim or drain-pan baseplates shall be furnished for horizontal pumps. The purchaser shall specify the rim or pan type as follows: drain rim surrounding the entire baseplate; drain pan surrounding the entire baseplate; partial drain pan that covers the entire width of the baseplate.
The rim or pan of the yahoo.com baseplate shall be sloped at least 1 in 120 towards the pump end, where a tapped drain opening of at least DN 50 (NPS 2) shall be located to effect complete drainage. CENTRIFUGAL PUMPS FOR PETROLEUM, PETROCHEMICAL AND NATURAL GAS INDUSTRIES The baseplate shall extend under the pump and drive-train components so that any leakage is contained within the baseplate. To minimize accidental damage to components, all pipe joints and pipe flange faces, including pump suction and discharge flanges, shall be within the drain-pan or drain-rim asme download collection area.
All other projections of the equipment supplied shall fall within the maximum perimeter of the baseplate. Oversized junction boxes may overhang the perimeter of the baseplate with the purchaser's approval. 7.3.3 If driver and pump size permit, baseplates shall have standardized dimensions as given in Annex D and shall be designed for grouting. These baseplates shall be referred to as Standard baseplates, numbers 0,5 to 12. 7.3.4 The height of the pump-shaft centreline above the baseplate shall be minimized. Adequate clearance shall b
